Product Summary
Innokin Z Pod Nano Replacement Pods keep your Z Pod Nano kit topped up, with a 2ml capacity and a built-in mesh coil in each pod for smooth MTL vaping. Choose the 0.8 ohm version at 12 to 14 watts for a touch more vapour, or the tighter 1.2 ohm pod at 9 to 12 watts. Both fill from the side and pair best with 50/50 e-liquid. Ideal spares for any Innokin Z Pod Nano owner.
Innokin Z Pod Nano Replacement Pods keep your Z Pod Nano kit topped up and tasting fresh. Each pod holds 2ml and clicks straight into place, so a quick swap gets you vaping again in moments.
You can choose a 0.8 ohm or a 1.2 ohm pod, and both use a built-in mesh coil for smooth, flavour-led mouth to lung vaping. As a result, there is a version for a slightly warmer draw and one for a tighter, more cigarette-like inhale.
Which kits do these pods fit?
These pods are made for the Innokin Z Pod Nano kit, so they drop straight in without any fuss. You will also find the Z Pod Nano kit in our range, ready to pair with a fresh set of pods. The table below lists both versions at a glance.
| Z Pod Nano Pod Guide Table | |
|---|---|
| 0.8 Ohm (2 Pack) | Built-In Mesh Coil, 12 to 14W, MTL |
| 1.2 Ohm (2 Pack) | Built-In Mesh Coil, 9 to 12W, Tighter MTL |
Which version should you choose?
For a tighter mouth to lung draw, pick the 1.2 ohm pod, which runs best at 9 to 12 watts. Meanwhile, the 0.8 ohm pod steps up to 12 to 14 watts for a touch more warmth and vapour.
Both options use a mesh coil, so the flavour stays clear either way. On top of that, they both pair best with a 50/50 e-liquid, which suits nic salts and standard blends alike.
Fitting and care
Push a fresh pod into your kit until it clicks firmly into place. Then fill it from the side by lifting the small silicone stopper, adding your e-liquid and pressing it back down.
Because a new coil needs to soak first, wait a few minutes before your first puff. In short, prime it early and the flavour will last much longer.
What's in the pack
- 2 x Innokin Z Pod Nano Replacement Pods
