Product Summary
Innokin Plexus Replacement Pods keep your Innokin Plexus Pro or Plexus Go pod kit topped up with a fresh 2ml pod and a built in mesh coil. Each pod comes in a two pack and fills from the top. Choose the 1.2 ohm pod for a tight mouth to lung draw, or the 0.6 and 0.8 ohm pods for an airier restricted direct to lung vape. Pair them with 50% VG e-liquid. Ideal spares for any Plexus owner.
Innokin Plexus Replacement Pods keep your Plexus pod kit topped up and tasting fresh. Each pod holds 2ml of e-liquid and clicks straight into your device, so a quick swap gets you going again. Because the mesh coil is built in, there is nothing to rebuild, so you simply fit a new pod when the flavour starts to fade.
Every pod also uses a top filling design, so you just lift the stopper and add your e-liquid. You can pick from three resistances to suit your style, from a tight mouth to lung draw to an airier restricted direct to lung vape. Innokin recommends pairing them with 50% VG e-liquid for the best results.
Which kits do these pods fit?
These pods are made for the Innokin Plexus Pro pod kit. The Innokin Plexus Go is also compatible with all Plexus pods, so the same spares cover both devices. You will also find the Plexus Pro and Plexus Go kits in our range. The table below lists every version at a glance.
| Plexus Pod Guide Table | |
|---|---|
| 0.6 Ohm (2 Pack) | Built-In Plexus Mesh Coil, RDTL Vaping, Top Fill |
| 0.8 Ohm (2 Pack) | Built-In Plexus Mesh Coil, RDTL Vaping, Top Fill |
| 1.2 Ohm (2 Pack) | Built-In Plexus Mesh Coil, MTL Vaping, Top Fill |
Which version should you choose?
Your choice comes down to the draw you enjoy. The 1.2 ohm pod gives a tight mouth to lung draw, so it suits higher nicotine strengths and a cigarette like inhale. Meanwhile, the 0.6 ohm and 0.8 ohm pods open things up for a restricted direct to lung vape with a little more vapour.
Every pod uses a built in Plexus mesh coil made from Kanthal, so its large mesh surface heats up quickly for improved flavour. For the best results, pair any resistance with 50% VG e-liquid.
Fitting and care
Fitting a pod is simple. First, push a fresh Plexus pod into your kit until it clicks firmly into place. Then lift the silicone stopper on top, add your e-liquid and reseal it. Because a new coil needs to soak, wait a few minutes before your first puff so the mesh can absorb the e-liquid.
What's in the pack
- 2 x Innokin Plexus Replacement Pods (per pack)
