Product Summary
GeekVape J replacement pods fit the GeekVape Digi Max and Digi Pro kits, each holding 2ml with a built-in mesh coil for MTL and RDTL vaping. Choose the 0.6, 0.8 or 1.2 ohm pod for a tight mouth to lung draw, or the 0.4 ohm pod for an airier restricted direct to lung vape. All four come as a handy two pack. Ideal spare pods for any Digi Max or Digi Pro owner.
GeekVape J replacement pods keep your Digi Max or Digi Pro kit running at its best. Each cartridge holds 2ml of e-liquid and clicks straight into place. So swapping a spent pod takes only a moment.
Every pod has a built-in mesh coil sealed inside. As a result, you simply replace the whole pod once the flavour fades. The range covers both MTL and RDTL vaping, and each pod also fills quickly from the top.
Which kits do these pods fit?
These pods are made for the GeekVape J pod system. They fit the GeekVape Digi Max and the GeekVape Digi Pro vape kits. You can browse both in our GeekVape pod kits range.
The table below lists every resistance at a glance. Each option is a two pack, so you always have a spare on hand. Then you can match the coil to your preferred draw style.
| Geekvape J Pod Guide Table | |
|---|---|
| 0.4 Ohm Top Fill (2 Pack) | Built-In Mesh Coil, 23 to 28W, RDTL |
| 0.6 Ohm Top Fill (2 Pack) | Built-In Mesh Coil, 16 to 21W, MTL |
| 0.8 Ohm Top Fill (2 Pack) | Built-In Mesh Coil, 12 to 17W, MTL |
| 1.2 Ohm Top Fill (2 Pack) | Built-In Mesh Coil, 8 to 12W, MTL |
Which version should you choose?
For a tight mouth to lung draw, pick the 1.2 ohm, 0.8 ohm or 0.6 ohm pod. They run best between 8 and 21 watts, so they suit a cigarette-like inhale. Pair them with a 50/50 e-liquid or a nic salt.
The 0.4 ohm pod opens things up for a restricted direct to lung vape. It runs warmer at 23 to 28 watts. Therefore it works best with a thicker 70% VG e-liquid at a lower strength.
Fitting and care
Push a fresh pod into your kit until it clicks firmly into place. Each pod fills from the top, so lift the stopper, add your e-liquid and reseal it. You can also fine tune the airflow with the slider on the side of the pod.
Because a new coil needs to soak, wait a few minutes before your first puff. This step primes the mesh and helps prevent dry hits. In short, a brief wait keeps the flavour clean and the coil healthy.
What's in the Pack
- 2 x GeekVape J Replacement Pods
