Product Summary
FreeMax Rexa Replacement Pods keep your Rexa kit vaping at its best, with a 2ml side-fill pod that clicks into the Rexa Lite, S, Pro, Nano, SQ and Smart. Each pod carries a built-in mesh coil, and it comes in 0.4, 0.8, 1.0 and 1.2 ohm, plus a removable 0.4 ohm DuoMax. The tighter resistances suit mouth to lung vaping, while the 0.4 ohm pods open up for an airier restricted direct to lung draw. Ideal spares for any Rexa pod kit owner.
FreeMax Rexa Replacement Pods keep your Rexa pod kit performing at its best. Each pod holds 2ml, and it clicks straight into your device, so swapping a tired pod takes only a moment.
You can choose from several built-in mesh coil resistances, and there is also a DuoMax version. As a result, there is a pod for both discreet mouth to lung and airier restricted direct to lung vaping.
Which kits do these pods fit?
These pods fit right across the Rexa pod family. That includes the Rexa Lite, Rexa S, Rexa Pro, Rexa Nano, Rexa SQ and Rexa Smart kits.
You will find the whole range on our FreeMax pod kits page. Meanwhile, the table below lists every version at a glance, so you can match a pod to your device quickly.
| Rexa Pod Guide Table | |
|---|---|
| 0.4 Ohm (3 Pack) | Built-In Mesh Coil, 24 to 28W, RDTL |
| 0.8 Ohm (3 Pack) | Built-In Mesh Coil, 12 to 15W, MTL |
| 1.0 Ohm (3 Pack) | Built-In Mesh Coil, 10 to 12W, MTL |
| 1.2 Ohm (3 Pack) | Built-In Mesh Coil, 8 to 10W, MTL |
| 0.4 Ohm DuoMax (3 Pack) | Built-In Mesh Coil, 24 to 28W, RDTL, Removable Bottom-Fill |
Which version should you choose?
For a tighter mouth to lung draw, pick the 1.2 ohm or 1.0 ohm pod, which run best at lower wattages. The 0.8 ohm pod then steps up slightly for a warmer mouth to lung inhale.
Alternatively, the 0.4 ohm pod opens up to 24 to 28 watts for an airier restricted direct to lung vape. The DuoMax version shares that 0.4 ohm resistance, yet it is removable and refills through a sliding cover. Every version pairs best with 50/50 e-liquid.
Fitting and care
Push a fresh pod into your Rexa kit until it clicks firmly into place. Standard Rexa pods sit above the device, so you can lift the rubber plug and refill them without removing the pod first.
The DuoMax pod instead comes out of the device, and you then slide its fill port cover down to add e-liquid. Afterwards, close the port again. Because a new coil needs to soak, wait a few minutes before your first puff.
What's in the pack
- 3 x FreeMax Rexa or Rexa DuoMax Replacement Pods (depending on the version chosen)
