Which kit do these pods fit?

These pods fit the Doozy Infinity pod kit only. The 0.8 ohm cartridge is made for that device, so it clicks straight into place. As a result, you keep the same tight draw every time you refill.

How does the built-in coil work?

Each pod has a mesh coil built inside it. When the flavour starts to fade, you replace the whole pod with a fresh one. So there is no separate coil to change or maintain.

What nicotine strength should I use?

The 0.8 ohm coil gives a tight MTL draw, so it suits nicotine salts or a balanced 50/50 blend. If you smoke around 10 a day, a 10mg salt is a good start. Lighter smokers often prefer 5mg, while heavier smokers may want 20mg.

How do I refill these pods?

These pods fill from the bottom. Turn the pod over, open the silicone port, then add your e-liquid and close it again. Because a new coil needs to soak, wait a few minutes before your first puff.

Doozy Infinity Replacement Pods | 2ml 0.8 Ohm Three Pack

Product Summary

The Doozy Infinity Replacement Pods keep your Doozy Infinity pod kit running with a 2ml capacity and a 0.8 ohm built-in mesh coil. They fill from the bottom, so topping up stays quick and clean. The tight mesh coil suits mouth to lung vaping, and pairs well with 50% VG e-liquid or nicotine salts. Each pack holds three pods. Ideal spares for any Doozy Infinity owner.

The Doozy Infinity Replacement Pods keep your Doozy Infinity kit running. Each pod holds 2ml of e-liquid and uses a 0.8 ohm built-in mesh coil. So when the coil fades, you simply swap the whole pod for a fresh one.

These pods fill from the bottom and are designed to stay leak proof. Because the mesh coil heats evenly, it also lifts flavour and gives steady vapour on every draw. Every pack contains three pods.

Which kits do these pods fit?

These pods are made for the Doozy Infinity pod kit only. Doozy built the 0.8 ohm cartridge for that device, so it clicks straight into place. As a result, you get the same tight draw and flavour each time you refill. You can also browse more compact pod kits if you want a spare device. The table below shows the version at a glance.

Infinity Pod Guide
0.8 Ohm Pod (3 Pack)	Built-In Mesh Coil, 2ml, Bottom Fill, MTL

How the 0.8 ohm pod vapes

The 0.8 ohm coil sits just above sub ohm, so it gives a tight mouth to lung draw much like a cigarette. It works best for MTL vaping and produces a smaller, cooler amount of vapour. For the smoothest results, pair it with a 50% VG e-liquid. Nicotine salts also suit this tight draw, so a smooth nicotine salt makes a great match.

Fitting and care

First push a fresh pod into the Infinity until it clicks. Then turn it over, open the bottom fill port, and add your e-liquid. Because a new coil needs to soak, wait a few minutes before your first puff. The mesh coil sits inside the pod, so there is nothing else to clean or maintain. You can top up with any Doozy e-liquid once it is fitted.