Product Summary
Voopoo Argus Replacement Pods fit the full Argus pod family, from the Argus P1 and Argus Z2 to the Argus G3, Klyc, Matrix and Argus P3. Every pod holds 2ml and clicks straight into place. Choose built-in mesh coil pods in 0.4, 0.7 or 1.0 ohm for MTL and RDTL vaping, or an empty No Coil pod that takes separate Voopoo ITO coils. Ideal spares for any Argus pod kit owner.
Voopoo Argus Replacement Pods keep your Argus pod kit running at its best. Each pod holds 2ml and clicks straight into your device, so swapping a tired pod takes only a moment.
You can choose built-in coil pods in several resistances, or an empty No Coil pod that takes separate Voopoo ITO coils. As a result, there is a version for mouth to lung and restricted direct to lung vaping alike.
Which kits do these pods fit?
These pods fit right across the Argus pod family. That includes the Argus, Argus P1, Argus G, Argus P1s, Argus G2, Argus G2 Mini, Argus P2, Argus Z, Argus Z2, Argus G3, Argus G3 Mini, Argus Klyc, Argus Matrix, Argus P3 and Argus A.
You will also find the Argus P1 and Argus Pod kits in our range. However, the 0.4 ohm pod does not fit the Argus P1 or Argus Z. The table below lists every version at a glance.
| Argus Pod Guide Table | |
|---|---|
| 2ml No Coil (2 Pack) | Empty Pod, Takes Voopoo ITO Coils, Side Fill |
| 0.4 Ohm Top Fill (3 Pack) | Built-In Mesh Coil, 18 to 30W, RDTL |
| 1.0 Ohm Top Fill (3 Pack) | Built-In Mesh Coil, 10 to 14W, MTL |
| 0.4 Ohm V2 Top Fill (3 Pack) | Built-In Mesh Coil, 18 to 30W, RDTL |
| 0.7 Ohm V2 Top Fill (3 Pack) | Built-In Mesh Coil, 14 to 18W, MTL |
| 1.0 Ohm V2 Top Fill (3 Pack) | Built-In Mesh Coil, 10 to 14W, MTL |
Which version should you choose?
For a tight mouth to lung draw, pick the 1.0 ohm pod, which runs best at 10 to 14 watts. The 0.7 ohm V2 pod steps up to 14 to 18 watts for a slightly warmer inhale. Meanwhile, the 0.4 ohm pod opens up to 18 to 30 watts for an airier restricted direct to lung vape.
Every built-in option uses a mesh coil, and all of them pair best with 50/50 e-liquid. If you would rather cut down on waste, the empty No Coil pod takes a separate Voopoo ITO coil instead.
Fitting and care
Push a fresh pod into your kit until it clicks firmly into place. Built-in coil pods fill from the top, while the empty No Coil pod fills from the side. In both cases, simply lift the silicone stopper, add your e-liquid and reseal it. Because a new coil needs to soak, wait a few minutes before your first puff.
What's in the pack
- 3 x Voopoo Argus built-in coil pods, or
- 2 x Voopoo Argus empty No Coil pods (depending on the version chosen)
